Bosch Wtl 6401 Manual Dexterity

View and Download BOSCH WTL 6101 instruction manual and installation instructions online. WTL 6101 Dryer pdf manual download. User guide • Read online or download PDF • Bosch Maxx WTL 6500 User Manual • Bosch Dryers. Manuals Directory ManualsDir.com - online owner manuals library. Bosch manuals. Download videopad video editor full version with crack. Maxx WTL 6500. En Instruction Manual.

• 7482 Answers SOURCE: ALWAYS UNPLUG YOUR DRYER BEFORE ATTEMPTING TO DO ANY WORK ON IT. Check to make sure you are getting full 220 Volt power to the dryer, if you are then: Check your Wiring Often the main wiring connection from the house, at the dryer, burns and the connection breaks. If this has happened to your dryer, you need to replace the power cord and the terminal block inside the dryer to which the wire is attached. Check the Door Switch If the door switch or the door-switch actuator is defective, the dryer won't work and you need to replace the failed component.

The switch is inside the dryer main housing near the door frame. Sometimes you need to raise or open the top or front of the dryer to reach the switch. Check for continuity you should have none with door open, and should have a reading when closed.

If not replace the door switch. Check to make sure you heating problem is not a lint build up in the discharge hose or the dryer,as this condition can cause heater/thermistor problems such as overheating of the heating coil leading to failure of the coil and burnout of the thermostat/thermistor due to overheat. Remove the back/or front just under the door of the machine and try to locate the air duct going from the blower to the drum. Normally inside/outside the air duct you will find the heating coil and the thermostats/thermistors. Once you have located the heating coil, remove the two wires from it and check the coil with an ohm meter across the two terminals of the coil.

You should read continuity across the terminals, if not you will need to replace the coil as it is faulty. If the heating coil is ok, then: You can check the thermostat/thermistor one at a time by removing the two wires and taping them together with electrical tape and running the dryer to check to see if the element is red or not, or with an ohm meter check the two terminals of the thermostat/thermister after you have removed the wires, the thermostat/thermistor should have/show continuity across the terminals. If the coil heats up, or the thermostat/thermistor shows an open circut then replace the thermostat/thermistor as it is defective. (Thermal fuse.If it overheats the dryer will not operate. It's located on the blower housing. It cannot be reset.

A vent clogged with lint can cause it to overheat. You can test it with an Ohm meter or continuity checker, if no continuity, replace it) DO NOT LEAVE THE WIRES TAPED TOGETHER AFTER THE TEST. This could cause a FIRE, as you have removed the safety of overheat from the machine. Right after replacing a dryer element, always run the dryer on 'air fluff' / 'no heat', and go outside to verify there's plenty of air coming out your vent system. If the vent's clogged, that new element can burn out very quickly. For video and pictures on how to replace the an element go to the following website, it will give you an idea what you are in for: davesrepair.com/DIYhelp/DIYreplacingWPLdryels.htm This is a FREE answer, Please rate me Posted on Jan 02, 2011.